C
HAPTER
2
| Hardware Description
Rear Panel
– 20 –
RJ-45 PORTS
The switch contains 8 100BASE-TX RJ-45 ports. All ports support automatic MDI/
MDI-X operation, so you can use straight-through cables for all network
connections to PCs or servers, or to other switches or hubs.
Each of these ports support auto-negotiation, so the optimum transmission
mode (half or full duplex), and data rate (10 or 100 Mbps) is selected
automatically.
Each port also supports IEEE 802.3x auto-negotiation of flow control, so the
switch can automatically prevent port buffers from becoming saturated.
REAR PANEL
The rear panel of the switch features a power socket.
Figure 2: SMCFS801P Switch Rear Panel
AC POWER SOCKET
Connect the female connector of the power cord here, and the male connector to
the AC power outlet. Make sure the voltage of the power supply meets the
requirement of the input voltage.
To Next Page
Loading...
Need help?
General