錯誤! 尚未定義樣式。
40
SMC8014WN and SMC8014WN2 Wireless Cable Modem Gateway Administrator Manual
Table 8. Remote Management Settings Menu Options
Option Description
WAN IP Address Read-only screen that shows the IP address used to access the Gateway’s Web
management interface via the Internet. For example, if the WAN IP address is 123.45.67.8
and the Web management port is 8080, remote users type http://123.45.67.8:8080
to access
the Web management interface. To change the value shown, check the box to the right of this
option and enter a new value.
Http Port Port number used to access the Gateway’s Web management interface. Range is from 1024
to 65535. Default is 8080. To change the value shown, check the box to the right of this option
and enter a new value.
Telnet Port Port number used to Telnet into the Gateway. Range is from 1 to 65535. Default is 2323. To
change the value shown, check the box to the right of this option and enter a new value.
Https Port Port number used to access the Gateway via a secure HTTPS connection. Default is 8181.
To change the value shown, check the box to the right of this option and enter a new value.
SSH Port Port number used to access the Gateway via a Secure Sockets Shell (SSH) connection.
Default is 2222. To change the value shown, check the box to the right of this option and
enter a new value. Note that SSH enables access to the Command Line Interface (CLI). For
more information, refer to the CLI command documents provided separately.
Mso remote management Enables or disables remote access to administrator configuration options.
• Checked = administrator remote management is enabled. (default)
• Unchecked = administrator remote management is disabled.
Customer remote management Enables or disables remote access to user configuration options.
• Checked = user remote management is enabled.
• Unchecked = user remote management is disabled. (default)
Limit remote management to By default, enabling remote management makes the device available to all IP addresses.
To limit remote management to a subset of IP addresses, perform the following steps:
• Uncheck All IP Addresses.
• Select Single Address or Address Range from the drop-down list.
• Enter the IP address or address range in the fields.
• Click Add. The IP address pr address range appears in Permitted IP Addresses.
To delete an IP address or address range, perform the following steps. No precautionary
message appears before you delete an IP address.
• Click the address in Permitted IP Addresses.
• Click Delete.
To Next Page
Loading...
Need help?
General
