SMC Networks ZSE20B-L User Manual

-28-
No.PS※※-OMV0006-D
Function Selection Mode
■Function selection mode
In measurement mode, press the button between 3 and 5 seconds, to display [F 0]. Select to display
the function to be changed [F□□]. Press and hold the button for 2 seconds or longer in function
selection mode to return to measurement mode.
∗: Some products do not have all the functions. If no function is available or selected due to configuration of other functions, [- - -] is
displayed on the sub display (right).
■Default setting
The default setting is as follows.
If no problem is caused by this setting, keep these settings.
To change a setting, enter function selection mode.
●[F 0] Display units, switch output specifications and diagnostic information selection function
Page 30
Units specification
Pressure range
Default setting
"Nil" or M
ISE20B
MPa
ZSE20B(F)
kPa
P
ISE20B
psi
ZSE20B(F)
Item
Default setting
Switch output specifications
PNP
Diagnostic information
ALL

SMC Networks ZSE20B-L Specifications

General

Brand	SMC Networks
Model	ZSE20B-L
Category	Switch
Language	English