-12-
PS##-OMM0003-A
Terms Meaning
Hysteresis Difference between the points at which the Pressure switch is turned on and off.
H
Hysteresis mode Refer to "List of output mode" on page 28.
Indication accuracy Shows the deviation between displayed pressure value and the true pressure.
Indication color
The color of the digital display. There are four choices: usually green, usually red,
green (off) to red (on), and red (off) to green (on).
Indication light The light that turns on when the switch output is on.
Insulation resistance
Insulation resistance of a product itself. The resistance between an electric circuit
and a body.
Indication resolution
How fine the rated pressure range can be segmented. (Example: If a product for 0
to 1 MPa can indicate pressure by 0.001 MPa, the indication resolution is 1/1000.)
Indication unit The unit of pressure used in the display.
I
Internal voltage drop See "Residual voltage".
K
Key lock (function) Prohibits a change in the setting of the Pressure switch (locks button operation).
L
Load impedance See "Max. load impedance".
Manual setup
Manual pressure setup without using auto preset. This term is used to
discriminate from the pressure setup using auto preset.
Max. applied voltage
The maximum value of applied voltage available to the output line of the NPN
output.
Max. load current The maximum current available to the output (output line) of the switch output.
Max. (Min.) load impedance
The maximum load (resistance value and impedance) which can be connected to
the output (output line) of the analog current output.
Measurement mode
The condition in which the pressure is being detected and indicated and switch
operation is enabled.
(Refer to "Measurement mode" on page 21.)
M
Min. setting unit Refer to "digit".
Normal output
One of the switch output types, and means the operation in which a switch is
turned on when pressure equal to the switch output set value or more is
detected. In the (hysteresis mode) window comparator mode, it indicates the
operation in which a switch is turned on when pressure in the switch output range
(P1L to P1H or P2L to P2H) is detected.
(Refer to "List of output mode" on page 28.)
N
NPN (open collector) (output) The switch that uses the NPN transistor for output.
To Next Page
Loading...
Need help?
General
