Snapper 1650 Series User Manual

FIG. 3.10--PARKING BRAKE/SPEED SELECTOR
FIG. 3.12-FORWARD/REVERSE PEDAL
5. Depress the left pedal and hold all the way
down. Adjust the selector link adjuster screw
(5igure 3.6-item 3) until there is zero clearance
between the end of the screw and the selector
link.
6. After making the selector link adjustment, if the
adjuster screw does not appear to hit squarely
against the selector link, it will be necessary to
replace the adjuster screw with a 5/16x1-1/4 hex
head bolt (Figure 3.9). Loosen the jam nut on
the adjuster screw and remove the screw. In¬
stall the hex head bolt and jam nut with the
head of the bolt toward the selector link to in¬
crease the area of contact between the adjust¬
ment bolt and the selector link. Make adjust¬
ment as previously described and lock jam nut.
HYDROSTATIC DRIVE CONTROL
On tractors with hydrostatic transmission, the for¬
ward/reverse pedal on the right side controls the
direction of travel. The tractor should move forward
when the forward or toe of the foot pushes the pedal
down and rearward when the heel pushes the lower
part of the pedal down. When the heel or toes are not
pressing against the pedal, the tractor should stop
and remain stationary provided the engine is runn¬
ing. The Parking brake pedal and lever on left side
must be engaged to brake and keep the tractor sta¬
tionary when the engine is stopped.
Before attempting to adjust the transmission
linkage on hydrostatic drive tractors, perform
follong checks;
7. Place the parking brake brake lever into the
first speed notch and tighten the nut on the end
of the brake rod until there is 1/8 inch clearance
between the nut on the rod and the brake
engaging sleeve of the linkage (Figure 3.9). In¬
stall and lock a jam nut against the brake rod
nut.
8. TEST BRAKES by placing tractor on level sur¬
face. With engine off, HI-LO shift lever in
neutral and parking brake set, attempt to roll
tires by pushing tractor. If tires roll, brake must
be readjusted.
FIG. 3.11-CONTROLS LEVERS LOCATION
1. Mid-Mount. 2. Thro* Point Hitch.
3. HI-LO Shifter. 4. Rear P.T.O.
1. Start tractor.
2. Place rear axle shift lever in low speed range.
3. Release neutral return and brake pedal.
4. Place right foot on heel and toe pedal.
5. Tilt right foot to rotate toe end of pedal downward.
Tractor should travel forward.
6. Remove foot from pedal, tractor should stop and
remain stopped.
7. Place right foot on pedal and tilt foot to rotate heel
end of pedal downward. Tractor should travel rear¬
ward.
8. Remove foot from pedal, tractor should stop and
remain stopped.
FIG. 3.13-TRANSMISSION SHIFT ADJUSTMENT
1. Adjuster. 2. Retainer. 3. Cotter Pin.
3.4 3-0

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English