Snapper 1650 Series User Manual

ENGINE REMOVAL & INSTALLATION
REMOVAL-SINGLE CYLINDER
Refer to figures 6.6 and 6.7.
1. Remove hood and grille assembly.
2. Disconnect battery cables and electrical
wires from engine.
3. Disconnect cable from starter motor.
4. Shut off fuel and remove line from car¬
buretor.
5. Disconnect choke and throttle cables
from engine.
6. Remove battery ground cable bolt from
battery platform.
FIG. 6.6-COUPLER PIN & SLEEVE
1. Coupler Pin. 2. Coupler Sleeve.
7. Remove pin from drive coupler and slide
coupler sleeve rearward.
8. Remove engine mounting bolts and lift
engine out.
INSTALLATION - SINGLE CYLINDER
1. Position engine on frame and secure
with retaining bolts.
2. Reconnect cables, wires and fuel lines.
3. Slide drive coupler onto engine shaft
and secure with pin.
4. Install hood and grille assembly.
REMOVAL-TWIN CYLINDER
1. Remove hood and grille assembly.
2. Remove right side panel to gain access
to tractor belt tension adjustment.
3. Disconnect battery cables.
4. Close fuel tank shut-off, disconnect fuel
supply line from fuel pump and remove fuel
tank.
5. Disconnect electrical wiring (alternator
wire) at right rear of engine and remove har¬
ness clamp bolt.
FIG. 6.7-MOUNTING BOLT-SINGLE CYL.
6. Loosen traction belt tension by turning
nuts at lower portion of rod and remove pin
from end of rod.
7. Remove traction belts.
8. Remove retaining dip from traction
drive belt tension bracket.
9. Remove complete exhaust system and
disconnect throttle and choke cables from
engine.
10. Remove pin and slide coupling rear¬
ward on PTO shaft if equipped.
11. Disconnect battery cable from starter
motor.
12. Disconnect ignition wire from ignition
coil.
6.4 V-S

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English