Snapper 1650 Series User Manual

FIG. 8.3 - LINE ROUTING (SINGLE CYL.)
1. TANK OUTLET. 2. FUEL FILTER.
3. THROTTLE & CHOKE CABLES.
STEP 3: Unhook the retaining strap from
the tank bail or clamp, lift the bail then re¬
move the tank.
STEP 4: Remove the fuel cap-guage then
carefully dispose of the contaminated or
stale fuel remaining in the tank. Clean the
tank by swishing with clean gasoline. Clean
or replace the fuel lines at this time if excess¬
ive dirt or water was present.
STEP 5: Before installing the tank, check
the bottom and rear side of tank for evidence
of rubbing. Replace the vibration insulation
pads at rear and bottom if worn also replace
tank if worn then at these points. Reverse
foregoing procedure to reinstall tank.
FIG. 8.4 - LINE ROUTING (TWO CYL.)
1. TANK OUTLET. 2. THROTTLE CABLE.
3. FUEL FILTER. 4. FUEL PUMP.
CAUTION: Carefully route the fuel hoses
over the throttle cable away from the
rotating grass screen on engine to eliminate
chances of the screen cutting or wearing thru
the hoses during operation.
FUEL LINE ROUTING
Always route the fuel line above the th¬
rottle cable as shown in figure 8.1 to prevent
the rotating grass screen on the engine from
rubbing thru the hoses during operation!
This routing will keep the hoses sufficiently
away from the screen.
8.2

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English