Snapper 1650 Series User Manual

FIG. 1.12-1600 RIGHT PANEL (2)
& ATTACH MENT(1)
FIG. 1.8-ACCESS WITH LEFT PANEL REMOVED
FIG. 1.9-RIGHT PANEL (1) & ATTACHMENT (2)
FIG. 1.11-1600 LIFT SPECIAL NUT (1) & CAM(2)
SIDE PANELS & STEP PLATES
The step plates do not normally have to be
removed except for replacement purposes.
Each step plate is attached to the rear fender
at two points and to the frame at two points.
To replace, simply remove these fasteners,
install the replacement plate and secure with
the same fasteners.
The side panels are often removed for ac¬
cess to other components inside the tractor
frame. These are easily removed as follows:
STEP 1: Remove the console cover as describ¬
ed earlier in the section.
STEP 2: Each panel attaches to the frame at
three points. Remove the three flange lock
bolts (weldnuts on inside of frame) and lift
the upward and outward to remove.
NOTE: When removing the right side panel
on 1600 series, it will be necessary to detach
the lift lever from the shaft before pulling the
panel.
FIG. 1.10-1600 LIFT LEVER SCREWS (1)
& SUPPORTS)
FIG. 1.7 - LEFT PANEL (I) & ATTACHMENT(2)
STEP 3: Reverse the foregoing steps to rein¬
stall the side panels.
1.3 ^

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English