Snapper 1650 Series User Manual

FIG. 6.13-LIFTING OUT OF FRAME
INSTALLATION - TWIN CYLINDER
1. Position engine in place, start tension
bracket over pivot post at same time.
2. Continue aligning mounting brackets
with studs and secure engine in place with
retaining nuts.
3. Reconnect the following:
a. Ground strap
b. Ignition wire to coil
c. Electric clutch wire
d. Cable to starter motor
e. Throttle cable
f. Alternator wire at right rear of engine
4. Install choke
FIG. 6.14-ENGINE REINSTALLED
1. Oil Fill Tube. 2. Oil Drain Tube.
5. Install retaining clip on tension bracket
post.
6. Install exhaust system.
7. Slide PTO coupling (if equipped) for¬
ward on engine shaft and secure with pin.
8. Install traction drive belts and insert pin
at lower end of belt tension rod.
9. Adjust belt tension nut until length of
spring is 1-1/4" and secure with lock nut.
10. Install front PTO drive belts.
11. Install oil drain pipe and fill engine with
oil.
12. Install fuel tank and reconnect battery
cables.
13. Install hood and grille assembly.
6.6

Snapper 1650 Series Specifications

General

Brand	Snapper
Model	1650 Series
Category	Lawn Mower
Language	English