SolaX Power X1-Hybrid-3.7-D User Manual

10 Decommissioning
10.1 Disassemble the Inverter
Remove DC input line and AC output line of inverter.
Wait for at least 5 minutes to power off.
Remove all cable connections from the inverter.
Remove inverter from finger support the bracket.
Remove the bracket if necessary.
10.2 Packaging
10.3 Storage and Transportation
10.4 Waste Disposal
Decommisioning
11 Disclaimer
SolaX will keep right to explain all the contents in this user manual.
Disclaimer
Load the inverter into the original package if possible.
116
117
If the original package can not be found, you can also use the following
requirements of the carton packaging:
Bearing capacity of more than 30kg;
Easy to carry;
Can completely seal the cover.
If it is necessary to scrap the inverter or other related parts, be sure to
send the waste inverter and packaging materials to the designated
ocation for recycling by the relevant department.
The series inverters are transported, used and operated under limited
condition, such as environmental, electrical etc. We shall not be liable to
provide the service, technical support or compensation under conditions
listed below, including but not limited to:
Inverter is damaged or broken by force majeure (such as earthquake,
flooding, thunderstorm, lighting, fire hazard, volcanic eruption etc).
Inverter's warranty is expired and not extended.
Can't provide the inverter's SN, warranty card or invoice.
Inverter is damaged by man-made cause. Inverter is used or operated
against any items in local policy.
Inverter's installation, configuration, commissioning doesn't follow the
requirements mentioned in this manual.
Inverter is installed, refitted or operated in improper ways mentioned in
this manual without authority from us.
Inverter is installed, operated under improper environment or electrical
condition mentioned in this manual without authority from us.
Inverter is changed, updated or disassembled on hardware or software
without authority from us.
Obtain the communication protocol from other illegal channels.
Build monitoring, control system without authority from us.
Connect to other brands batteries without authority from us.
Store the inverter in a dry, temperature -40°C~ 65°C environment.
Pay attention to less than four inverters on each stack board during
storage and transportation.

SolaX Power X1-Hybrid-3.7-D Specifications

General

Brand	SolaX Power
Model	X1-Hybrid-3.7-D
Category	Inverter
Language	English