Printing images
135
Printing images
Specifying DPOF
Using the camera, you can specify the images and the number of images to
print before you print images at a shop or with your printer. Follow the
procedure below.
DPOF specifications are left with images after printing. It is recommended
that you unspecify them after printing.
DPOF specifications can be operated either using the Fn button or the
MENU button. Here operation using the Fn button is described.
Notes
• You cannot specify DPOF on RAW data files.
• You can specify any number up to 9.
Fn button t [Specify Printing] t [DPOF setup] t [All images]
or [Cancel all] t [OK] t [OK]
Specifying /unspecifying DPOF on selected images
1 Fn button t [Specify Printing] t [DPOF setup] t [Marked
images] t [OK]
2 Select the image with b/B on the control button.
3 Select the number of sheets with the center of the control
button.
• To unspecify DPOF, set the number to “0.”
4 Press the Fn button.
5 Select [OK] with v on the control button, then press the center
of the control button.
Specifying/unspecifying DPOF on all the images
To Next Page
Loading...
Need help?
General
