Help Guide
Wireless Stereo Headset
Float Run
Making a call
You can enjoy a hands-free call with a smartphone or mobile phone that supports the Bluetooth profile HFP (Hands-free
Profile) or HSP (Headset Profile), via Bluetooth connection.
If your smartphone or mobile phone supports both HFP and HSP, set it to HFP.
The operation may vary depending on the smartphone or mobile phone. Refer to the operating instructions supplied
with the smartphone or mobile phone.
Depending on the connected device or the application you are using, the functions may not work properly even if you
try to operate them with the headset.
Connect the headset to a smartphone or mobile phone via Bluetooth connection.
1
Operate your smartphone or mobile phone to make a call.
When you make a call, the dial tone is heard from the headset.
If you make a call during music playback, playback pauses.
If no dial tone is heard via the headset, switch the call device to the headset by using your smartphone or mobile
phone or by pressing and holding the
(call) button for about 2 seconds.
You can talk using the microphone on the headset.
A: Microphone on the remote control component
2
Adjust the volume by pressing the +/– buttons of the headset.
When the volume reaches the maximum or minimum, an alarm sounds.
3
When you finish your phone call, press the
(call) button on the headset to end the call.
If you made a call during music playback, music playback resumes automatically after ending the call.
4
To Next Page
Loading...
Need help?
General
