PHOTO (p. 20)
The on-screen image when you press this
button will be recorded as a still image.
SEARCH M.* (p. 29)
*
Video control buttons (Rewind,
Playback, Fast-forward, Pause, Stop,
Slow) (p. 21)
ZERO SET MEMORY*
Transmitter
REC START/STOP (p. 20)
Power zoom (p. 23)
DISPLAY (p. 14)
Memory control buttons (Index*, –/+,
Memory playback) (p. 21)
* These buttons are not available during Easy
Handycam operation.
• Aim the Remote Commander towards the
remote sensor to operate your camcorder (p.
24).
• To change the battery, see page 111.
Searching quickly for a desired
scene (Zero set memory)
1 During playback, press ZERO
SET MEMORY
at a point you
want to locate later on.
The tape counter is reset to “0:00:00”
and appears on the screen.
If the tape counter is not displayed,
press DISPLAY
.
2 Press STOP
when you want to
stop playback.
3 Press REW
.
The tape stops automatically when the
tape counter reaches “0:00:00.”
4 Press PLAY
.
Playback starts from the point
designated “0:00:00” on the tape
counter.
• There may be a discrepancy of several seconds
between the time code and the tape counter.
• Zero set memory will not function correctly
if there is a blank section between recorded
sections on the tape.
To cancel the operation
Press ZERO SET MEMORY
again.
To Next Page
Loading...
Need help?
General