61
Dubbing/Editing
DCR-HC32E/HC33E/HC39E/HC42E/HC43E 2-584-907-11(1)
Dubbing sound to a recorded tape
You can add sound to a tape already recorded in the 12-bit mode (p. 51) without erasing the
original sound.
Connecting
Active Interface
Shoe
Internal microphone
A/V connecting cable
(supplied)
Do not connect the
Video plug (yellow).
(white)
A/V jack
(red)
AUDIO OUT
: Signal flow
Audio device (such as CD/MD) players
You can record audio by connecting in one
of the following ways.
For DCR-HC39E/HC42E/HC43E:
An external microphone (optional) to the
Active Interface Shoe.
For DCR-HC32E/HC33E/HC42E/
HC43E:
An audio device to the Handycam
Station or your camcorder using the A/V
connecting cable.
Using the internal microphone (no
connection required).
The audio input to be recorded takes
precedence over others in the order of
.
You cannot record additional audio:
– When the tape has been recorded in the 16-bit
mode (p. 51).
– When the tape has been recorded in the LP
mode.
– When your camcorder is connected via an
i.LINK cable.
– When the tape has been recorded in 4CH MIC
REC mode on another device.
– When the tape has been recorded in a TV color
system other than that of your camcorder.
– On blank sections of the tape.
– When the write-protect tab of the cassette is set
to SAVE.
• The picture will not be output from the A/V
jack when dubbing audio:
– with the A/V jack of these models: DCR-
HC32E/HC33E/HC42E/HC43E.
Continued
To Next Page
Loading...
Need help?
General