12
GB
Listening to music from a
BLUETOOTH device
Pairing is an operation where
BLUETOOTH devices register with each
other beforehand. Once a pairing
operation is performed, it does not need
to be performed again.
1 Place the BLUETOOTH device
within 1 meter from the Bar
Speaker.
2 Press PAIRING on the Bar
Speaker.
The blue LED indicator on the Bar
Speaker flashes quickly during
BLUETOOTH pairing.
3 Turn on the BLUETOOTH function,
and then select “HT-CT390” after
searching for it on the BLUETOOTH
device.
Perform this step within 5 minutes,
otherwise pairing mode may be
canceled.
When the BLUETOOTH connection
is established, the blue LED
indicator lights up.
• If passkey is required on the BLUETOOTH
device, enter “0000”. Passkey may be
called “Passcode”, “PIN code”, “PIN
number” or “Password”.
• You can pair up to 9 BLUETOOTH devices.
If the 10th BLUETOOTH device is paired,
the least recently connected device will
be replaced by the new one.
1 Turn the BLUETOOTH function of
the paired device to on.
2 Press INPUT repeatedly to select
“BT”.
The system automatically
reconnects to the BLUETOOTH
device it was most recently
connected to.
When the BLUETOOTH connection
is established, the blue LED
indicator lights up.
3 Start playback on the BLUETOOTH
device.
4 Adjust the volume.
• Adjust the volume of the
BLUETOOTH device.
• Adjust the volume of Bar Speaker
by pressing +/–.
• Adjust the volume of subwoofer
by pressing SW +/–.
• Once the system and the BLUETOOTH
device are connected, you can control
playback by pressing and /.
• You can connect to the system from a
paired BLUETOOTH device even when the
system in standby mode, if you set the
“BTSTB” to “ON” (page 16).
• The audio playback on this system may
be delayed from that on the BLUETOOTH
device because of the characteristics of
the BLUETOOTH wireless technology.
BLUETOOTH Functions
Pairing this system with a
BLUETOOTH device
Notes
Listening to music from the
paired device
Notes
To Next Page
Loading...
Need help?
General
Weight and Dimensions
