27
GB
• You can enjoy high-quality sound if AAC is
enabled and your device supports AAC. If
you cannot listen to AAC sound with your
device, select [Off].
[Bluetooth Codec - LDAC]
This function is only available when you
set [Bluetooth Mode] to [Receiver] or
[Transmitter].
[On]
: Enable LDAC codec.
[Off]: Disable LDAC codec.
• You can enjoy more high-quality sound if
LDAC is enabled and your device supports
LDAC. If you cannot listen to LDAC sound
with your device, select [Off].
[Wireless Playback Quality]
You can set the transmission data rate of
LDAC playback. This function is only
available when you set [Bluetooth Mode]
to [Transmitter] and [Bluetooth Codec -
LDAC] to [On].
[Auto]: The transmission rate is
automatically changed depending on the
environment. If audio playback is
unstable in this mode, use the other three
modes.
[Sound Quality]: The highest bit rate is
used. Sound is sent in a higher quality;
however, audio playback sometimes may
become unstable when the link quality is
not good enough.
[Standard]
: The middle bit rate is used. It
balances both sound quality and
playback stability.
[Connection]: Stability is prioritized.
Sound quality may be reasonable and
connection status will most likely be
stable. If the connection is unstable, this
setting is recommended.
[OSD Language]
You can select the language you want for
the system on-screen display.
[Wireless Sound Connection]
You can make further settings for the
wireless system. For details, see “Further
Setting for the Wireless System
(Subwoofer/Surround speakers)”
(page 38).
[IR-Repeater]
[On]: Remote signals for the TV are sent
via an IR blaster (page 37).
[Off]
: Turns off the function.
[HDMI Settings]
[Control for HDMI]
[On]
: Turns on the [Control for HDMI]
function. You can operate mutually
between devices that are connected with
an HDMI cable.
[Off]: Off
[Audio Return Channel]
This function is available when you
connect the system to a TV’s HDMI IN jack
that is compatible with the Audio Return
Channel function and [Control for HDMI] is
set to [On].
[Auto]
: The system can receive the digital
audio signal of the TV automatically via an
HDMI cable.
[Off]: Off
[Standby Through]
You can output HDMI signals to the TV
even when the system is in standby
mode. This function is available when you
set [Control for HDMI] to [On].
[Auto]: Outputs signals from the HDMI
OUT (ARC) jack when the TV is turned on
while the system is in the standby mode.
This setting saves power in the standby
mode compared to the [On] setting.
Note
Note
[System Settings]
To Next Page
Loading...
Need help?
General
Weight and Dimensions
