Getting Started
16
Installing the TV
Preventing the TV
from Toppling Over
Attaching the Support Belt
1 Screw the support belt (supplied) to the TV stand with a wood screw
(supplied).
2 Attach the support belt to the stand with the securing screw (supplied)
using a coin, etc.
3 Adjust the length by pulling the support belt towards you while holding
the TV stand.
When Installing on a Wall
Be sure to use the specified Wall-Mount Bracket (see page 3) when
installing the TV on a wall. Refer to the Instruction Guide supplied with the
Wall-Mount Bracket (sold separately).
(See page 43 or 44 for Table-Top Stand removal.)
Be sure to take measures to prevent the TV from toppling over and
causing injury.
The supplied wood screw may not be used depending on the type of TV
stand. In this case, or when the securing strength is not enough,
prepare commercial screws to fit to the TV stand. Use commercial
screws of 3 to 4 mm (1/8 to 3/16 inches) diameter. Consult your dealer
about the types of screw.
To Next Page
Loading...
Need help?
General