Getting Started
18
Setting Up the Channel List - Initial Setup
After you finish connecting your TV, you need to run Initial Setup, which
automatically sets up available channels. The Initial Setup screen appears
when you turn on your TV for the first time. If you do not want to set up the
channels at this time, you can do it later by selecting the Auto Program
option in the Analog and Digital Setup settings (see pages 37 and 38).
1 Press to turn on the TV.
The Initial Setup screen appears.
2 Press V/v to highlight the on-screen display language. Then press .
The message “First please connect cable/antenna. Do you want to start
Auto Program?” appears.
3 Press B/b to highlight “OK” then press .
The message “Auto Program” appears. Then the message “Continue
programming digital channels?” appears. This may require 50+ minutes
for completion.
4 Press B/b to highlight “OK” then press .
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on pages 37 and 38.
To add individual digital channels
❑
Use the Digital Channels Add feature as described on page 38.
POWER
To Next Page
Loading...
Need help?
General