36
5 Set the time to start playback.
Press V or v to set the hour, then press
ENTER.
The minute indication starts flashing.
Press V or v to set the minute, then press
ENTER.
The hour indication flashes again.
6 Set the time to stop playback
following the above procedure.
7 Press V or v until the music source
you want appears.
The indications change as follows:
8 Press ENTER.
The type of timer (DAILY 1 or DAILY 2),
appears followed by the start time, stop
time and the music source, then the
original display appears.
9 Turn off the power.
To check the setting
Press TIMER SELECT and press V or v to
select the respective mode (DAILY 1 or
DAILY 2), then press ENTER. To change the
setting, start over from step 1.
To cancel the timer operation
Press TIMER SELECT and press V or v to
select “TIMER OFF”, then press ENTER.
Tip
The power turns on 15 seconds before the preset
time.
1
1
Waking up to music
— Daily Timer
You can wake up to music at a preset time
every day. Make sure you have set the clock
(see “Step 3: Setting the time”).
1 Prepare the music source you want
to play.
• CD: Insert a CD. To start from a
specific track, make a programme (see
“Programming the CD tracks”).
• Tape: Insert a tape with the side you
want to play facing forward.
• Radio: Tune in the preset station you
want (see “Step 4: Presetting radio
stations”).
2 Adjust the volume.
3 Press CLOCK/TIMER.
“SET (DAILY 1)” appears.
)0P
+=p
·
·ª
·ª
·
p
V
v
bB
TIMER SELECT
4 Press V or v to select DAILY 1 or 2,
then press ENTER.
“ON” appears and the hour digits flash
in the display.
2
3
4,5,8 4,5,7
9
n TUNER ˜ CD PLAY N
n TAPE PLAY N
To Next Page
Loading...
Need help?
General
