2. Getting started
This chapter describes the preliminary steps required to set up the
recorder and how to make connections before starting to use the
device.
Installing the remote control battery
Follow these instructions to insert the remote control battery:
1. Push in the clip at the side of the battery
holder.
2. Pull battery holder out.
3. Insert the battery as shown, while noting
the correct polarity.
4. Push battery holder and snap it in place.
MPEG-4 Video Recorder_UM_EN.book Page 7 Thursday, June 22, 2006 2:14 PM
To Next Page
Loading...
Need help?
General
