18-GB
z
• You cannot pause manually during synchro-recording.
• When there is no sound from the player for more than 3 seconds during
synchro-recording, the recorder goes into the standby mode automatically.
When the sound comes from the player again, the recorder resumes synchro-
recording. If the recorder is kept in the standby mode for 5 minutes or longer,
the recorder stops automatically.
Notes
• Do not switch SYNCHRO REC after step 3. Recording may not be done
properly.
• When recording in monaural, follow steps 1 to 3 of “Recording in monaural
for double the normal recording time” (page 20), and then do steps 1 and 3 of
synchro-recording.
• Even when there is no recorded sound on the sound source, there may be
cases when recording does not pause automatically during synchro-recording
due to the noise level emitted from the sound source.
• If a silent portion is encountered for 2 seconds or more during synchro-
recording, a new track mark is automatically added at the point where the
silent portion ends.
• Synchro-recording cannot be done if the connecting cord is not an optical
cable, or if the cable is connected to the MIC (PLUG IN POWER) jack.
• You cannot adjust the recording level manually during synchro-recording.
To Next Page
Loading...
Need help?
General