60
Setting the Timer (continued)
To clear timer settings
programmed for a specific
program number label
1 Keep the SET button
pressed for more than a
second.
“SET” appears on the LCD
display.
2 Press the SCROLL button
twice to display “CLEAR”
on one of the labels.
3 Select “CLEAR” by
pressing the Label Select
button.
SET
POWER ON
COPY
CLEAR
SYSDELAY
SET
POWER ON
COPY
CLEAR
SYSDELAY
If you select the program
number which has no timer
program data
The ‘NG’ sound is heard.
3 When you finish the setting
of the timer standby mode,
press any button other than
the SCROLL and Label
Select button.
The display turns to the
component operating mode.
The “TIMER” mark stays lit on
the display. This means that
one or more timer programs
are set to the timer standby
mode.
Notes
• If the TEST or ON/OFF label is
selected when the timer program is
not set, the ‘NG’ sound is heard
twice.
• The timer program contents you have
set on this Commander repeat daily
or weekly until you set the timer
standby mode to off. If you want to
execute the timer program once, set
the timer standby mode to off after
the execution of the timer program.
IMPORTANT
The timer function of this
Commander is designed for the
timer operation of AV
components. Do not use the
timer function to operate an air-
conditioner or electrical
appliances. It may cause a fire
or a serious injury.
TIMER
PROG1
PROG2
PROG3
PROG4
10:00 AM
SET
To Next Page
Loading...
Need help?
General
