46
GB
D:\NORM'S JOB\SONY HA\SO17_STR-DH590_PMRF1\STR-DH590 (PMRF
01)\4726906121_GB\070TRU.fm
masterpage: Left
STR-DH590
4-726-906-12(1)
“USB FAIL” appears on the display
panel.
An over-current from the POWER SUPPLY
port was detected. Turn off the receiver,
disconnect the USB device, and then turn
on the receiver again.
[Error 30:]
Headphones are connected. Please
disconnect the headphones and retry
calibration.
[Error 31:]
The speaker system is set to “OFF
SPEAKERS”. Press SPEAKERS on the receiver
repeatedly to select “SPK ON” and perform
Auto Calibration again.
[Error 32:], [Error 33: F], [Error 33: S]
• Sound is not detected from one or both
of the speakers.
– Sound is not detected from one or both
of the front speakers. Please ensure
that the calibration microphone is not
damaged, and is connected to the
CALIBRATION MIC jack on the front
panel of the receiver, and that all
speakers are properly connected.
– Sound is not detected from either the
left or right surround speakers. Please
ensure that the surround speakers are
connected to the SURROUND
terminals.
• Sound is not detected from any speakers,
please ensure that the calibration
microphone is not damaged and is
connected to the CALIBRATION MIC jack
on the front panel of the receiver.
[Warning 40:]
The measurement has been completed,
but the noise level is high. For best possible
results, calibrate in as quiet a place as
possible.
[Warning 41:], [Warning 42:]
The input signal from the calibration
microphone is too large. The microphone
may be too close to the speakers. Please
place the calibration microphone at your
desired listening position, and perform
Auto Calibration again.
[Warning 43:]
The distance and position of the subwoofer
cannot be detected. Please check the
subwoofer and re-calibrate in a quiet
environment.
Messages after Auto
Calibration measurements
To Next Page
Loading...
Need help?
General
Weight and Dimensions
