TlJning;"intoast,tiQh
,
..
;
·alltomatically
·(_ItJomaIU:·'
Tunilg)
....
..
1 Press TUNER repeatedly to
select the
FM
or
AM
band.
2 Press TUNING + or TUNING
-.
Press
TUNING
+ to scan from low to
high; press
TUNING
- to scan from high
to low,
The receiver stops scanning whenever a
station
is
received.
Using the controls
on
the
receiver
1 Turn INPUT
SELECTOR
to select the FM
or
AM band.
2 Press
TUNING
MODE
repeatedly to select
"AUTO".
3 Press TUNING +
or
TUNING
-.
In
case of poor
FM
stereo
reception
If
the FM stereo reception
is
poor and
"ST"
flashes on the display, select monaural audio
so that the sound will be less distorted.
1 Press AMP MENU.
2 Press
+1+
repeatedly
to
select
"TUNER",
then press 8
or
+.
3 Press
+1+
repeatedly to select
"FM
MODE", then press 8
or
+.
4 Press
+1+
repeatedly to select
"MONO".
then press
8.
To return to stereo mode, repeat steps I to 4
and select "STEREO" in step 4.
46
GB
You can enter the frequency
of
a station
directly by using the numeric buttons.
1 Press TUNER repeatedly
to
select the
FM
or
AM
band.
You can also use
INPUT
SELECTOR on
the receiver.
2 Press D.TUNING.
3 Press and hold SHIFT, then
press the numeric buttons
to
enter the frequency.
Example
1:
FM
102.50
MHz
• Models
of
area code U2 and
CA2:
Select I + 0 + 2 + 5
• Models
of
area code AU
1,
SA2 and
TW2:
Select I
+ 0 + 2 + 5 + 0
Example
2:
AM
1,350 kHz
Select 1
+ 3 + 5 + 0
4 Press and hold SHIFT, then
press ENTER.
You can also use MEMORYIENTER on
the receiver.
Tip
if
you have tuned
in
an
AM
station. adjust the
direction
of
the AM loop antenna (aerial) for
optimum reception.
If you cannot tune
in
a station
Make sure you have entered the right
frequency.
If
not, repeat steps 2 to 4.
If
you
still cannot tune in a station, the frequency
is
not lIsed
in
your area.
To Next Page
Loading...
