31
GB
D:\NORM'S JOB\SONY HA\SO0086\STR-DN610_PMRF 2\GB\GB04CON_STR-DN610-U2.fm masterpage: Right
STR-DN610
4-167-824-13(1)
Preparing the Receiver
Initializing the receiver
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their initial settings.
Be sure to use the buttons on the receiver for
this operation.
1 Press ?/1 to turn off the
receiver.
2 Hold down ?/1 for 5 seconds.
After “CLEARING” appears on the
display for a while, “CLEARED”
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Selecting the speaker
system
You can select the front speakers you want to
drive.
Be sure to use the buttons on the receiver for
this operation.
Press SPEAKERS repeatedly to
select the front speaker system
you want to drive.
* To select “SPK B” or “SPK A+B”, set “SB
ASGN” to “SPK B” in the SPEAKER menu
(page 65).
To turn off the speaker output
Press SPEAKERS repeatedly until “SPK
OFF” appears on the display.
Note
This setting is not available when the headphones
are connected.
Preparing the Receiver
?/1
?/1
To select the front speakers
connected to
Display
The SPEAKERS FRONT A
terminals
SPK A
The SPEAKERS SURROUND
BACK/BI-AMP/FRONT B terminals
SPK B*
Both the SPEAKERS FRONT A and
SPEAKERS SURROUND BACK/
BI-AMP/FRONT B terminals (parallel
connection)
SPK A+B*
?/1
SPEAKERS
To Next Page
Loading...
Need help?
General
Weight and Dimensions
