Sony STR-GX69ES User Manual

The two remote commanders must: |
e face straight each other.
e be placed at a distance of approx. Som (2 inches).
@ not be moved during programming operation.
After programming
Be sure to test if the equipment really works with the
programmed signals.
Number of signals that the commander can learn
It depends on the format of the signal. If you program
signals of Sony equipment, approximately 50 - 60 signals
can be programmed.
Memory capacity
If the LEARN indicator flashes or does not go out in step
2-@ , ® , the memory capacity has become full. This occurs
when other signals stronger than the remote-control signals
have been stored because the signals were programmed in
a noisy environment or the remote commanders were
placed too far apart from each other.
In this case, clear all the signals following the procedure
described below and program again from the beginning
under the proper conditions.
Notes on programming
@ Remote-control signals of equipment of manufacturers
other than Sony can be programmed only when they are
compatible with the infrared wireless remote control
system. Since the programmable commander can
“learn” only the signals output from another remote
commander, it cannot control equipment that does not
use a remote commander.
e Donot attempt to use the programmable commander
with an air conditioner or other household appliances.
@ Note that there are some special remote-control signals
that cannot be programmed.
|
Programming a new signal onto a previously
programmed button
Follow the programming procedure.
The previously programmed signal is cleared and replaced
by the new signal.
To clear all programmed signals
1 Set the mode selector to LEARN.
2 Press and hold any button of the programmable area
until the LEARN indicator lights up.
3 Press PROGRAM CLEAR until the LEARN indicator
flashes and goes off.
Note
It is not possible to clear the programmed content of just one
button.
To program a signal onto the @ REC button
It is not possible to operate any equipment with only the
@ REC button. To program a signal under the @ REC button,
press and hold the following buttons at the'same time in
step 2-@.
fel ah ice) ltlatem =colereleatcieis
By switching the mode selector as shown below, a single
button alternately controls Sony equipment and another
manufacturer equipment.
To control Sony equipment
USER STD
SONY
STD LEARN
To control equipment with programmed signals
USER STD
STD LEARN
When Sony equipment cannot be remote-controlied
Program the signal in the same way as for equipment from
other manufacturers. in this case, even with Sony
equipment, set the mode selector to USER STD.
Notes on Battery
If the LEARN indicator does not light when a button is
pressed, the batteries are almost exhausted.
When the batteries are exhausted, the remote commander
can no longer operate the unit or programming becomes
impossible.
If this happens, replace both batteries with new ones. We
recommend the use of alkaline batteries for prolonged use.
If no signal has been programmed
The programmable commander can control Sony
equipment even when the mode selector is set to USER
STD.
if the equipment works incorrectly
Press RESET.
The programmed contents of the buttons are not cleared by
pressing RESET.
OBR

Sony STR-GX69ES Specifications

General

Brand	Sony
Model	STR-GX69ES
Category	Receiver
Language	English