22
US
Using the hidden commands
Performing commands using the receiver
This receiver allows you to perform various commands using buttons on the front panel.
PING ENTER
AMP
MENU
2CH/DIRECT
MULTI ST.
Function Operation
User initialize (Memory Clear)
Hold down for 5seconds in standby mode.
Sound Field Clear
Hold down MULTI.ST. and press in standby mode.
Settings Lock Hold down PING and AMP MENU and press ENTER while the
receiver is turned on.
Command mode
(Remote Control)
Hold down 2CH/DIRECT and press in standby mode.
Performing commands using the supplied remote control
This receiver allows you to perform various commands using the supplied remote control.
Changing the remote control code
1 While holding down MAIN, press MAIN .
MAIN will start flashing.
2 Press CUSTOM PRESET 1 or 2 to select AV1 or AV2 as needed.
MAIN will stop flashing and light up in red.
3 Press .
MAIN will start flashing again.
4 Press again to set the command mode.
To Next Page
Loading...
Need help?
General
