Windows Media is either a registered trademark or trademark of Microsoft Corporation in the United States and/or
other countries.
This product is protected by certain intellectual property rights of Microsoft Corporation. Use or distribution of such
technology outside of this product is prohibited without a license from Microsoft or an authorized Microsoft
subsidiary.
Apple and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. Apple Carp lay is a
trademark of Apple Inc.
Android Auto is a trademark of Google LLC.
Weblink is a registered trademark of Ablate Technologies, Inc. in the U.S. and a trademark in the other countries.
All other trademarks are trademarks of their respective owners.
Connection/Installation
Cautions
Do not install this unit in a car that has no ACC position. The display of the unit does not turn off even after
turning the ignition off, and this causes battery drain.
Run all ground (earth) leads to a common ground (earth) point.
Do not get the leads trapped under a screw or caught in moving parts (e.g., seat railing).
Before making connections, turn the car ignition off to avoid short circuits.
Connect the yellow and red power supply leads only after all other leads have been connected.
Be sure to insulate any loose unconnected leads with electrical tape for safety.
Choose the installation location carefully so that the unit will not interfere with normal driving operations.
Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperature, such as in direct
sunlight or near heater ducts.
Use only the supplied mounting hardware for a safe and secure installation.
Be sure to use the supplied USB extension cables. · This unit may not be installed properly depending
on the car type. For details on the mounting space, see “Ensuring the mounting location of the unit” (page 12).
To avoid injury, be careful not to drop the display during installation.
When installing, be careful not to cut off your fingers with the metal parts of the brackets and mounting base.
Do not pinch your fingers when attaching the display to the unit.
Do not install the unit in a position where the unit interferes with driving operations (such as in positions where
the shift lever hits the unit, or the hazard button cannot be pressed).
When using the unit for a long period of time, there may be a possibility that the screws securing the display
may come loose. Periodically tighten these screws.
Do not make any changes or modifications to the unit other than those described in this manual.
Note on the power supply lead (yellow )
When connecting this unit in combination with other stereo components, the amperage rating of the car circuit to
which the unit is connected must be higher than the sum of each component’s fuse amperage rating.
Note on installing in cars with a start-stop system
To Next Page
Loading...
Need help?
General
