registration. When the registration is complete, the steering wheel remote control becomes available.
Notes on installing the connection cable RC-SR1
Refer to the support site on the back cover for details then connect each lead properly to the appropriate leads.
Making an improper connection may damage the unit.
Consulting the dealer or an experienced technician for help is recommended.
When using the wired remote control
1. To enable the wired remote control, set [Steering Control] in [General] to [Preset].
Using the rear view camera
Installation of the rear view camera (not supplied) is required before use. The picture from a rear view camera
connected to the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
Installation
To install the unit and the display securely, be sure to follow the steps to in order.
Before mounting the unit (page 15)
Mounting the unit in the dashboard (page 16)
Attaching the joint cover (page 16) Setting up the display (page 16)
Making sure the mounting positions of the display (page 18)
Organizing the USB cable (page 18)
Attaching the display to the unit (page 18)
For your safety
After mounting the display to the unit, make sure that the display does not interfere with normal driving operations
such as blocking the driver’s view or getting the cables tangled.
Before mounting the unit
Before mounting the unit in the dashboard, arrange the USB extension cables.
USB cable connection diagram
To Next Page
Loading...
Need help?
General
