Help Guide
Wireless Noise Canceling Stereo Headset
WF-1000XM4
Using the noise canceling function
If you use the noise canceling function, you can enjoy music without being disturbed by ambient noise.
About the instruction manual video
Watch the video to find out how to use the noise canceling function.
https://rd1.sony.net/help/mdr/mov0023/h_zz/
Hint
You can also turn on/off the noise canceling function and change the settings of the noise canceling function and Ambient Sound
Mode with the “Sony | Headphones Connect” app.
You can select one of the following on the “Sony | Headphones Connect” app to set how you want the functions to change when
you tap the left unit of the headset.
Noise canceling function: ON
Ambient Sound Mode: ON Noise canceling function: OFF/Ambient Sound Mode: OFF
Noise canceling function: ON
Ambient Sound Mode: ON
Ambient Sound Mode: ON
Noise canceling function: OFF/Ambient Sound Mode: OFF
Noise canceling function: ON
Noise canceling function: OFF/Ambient Sound Mode: OFF
When only one unit of the headset is worn, the Ambient Sound Mode is set to ON, even if the headset was set to the noise
canceling function when you used the headset last. Putting on both headset units will automatically turn on the noise canceling
function.
Remove the headset from the charging case and then put the headset units into your ears.
When you turn the headset on for the first time after purchase or just after initializing the headset, the noise
canceling function is turned on automatically when you put the headset units into your ears.
Any changes made to the settings are retained from this point on.
1
Tap the touch sensor on the left unit to change the settings of the noise canceling function.
Each time you tap, the function switches as follows.
Ambient Sound Mode: ON
You will hear the voice guidance say, “Ambient sound”.
Noise canceling function: ON
You will hear the voice guidance say, “Noise canceling”.
2
To Next Page
Loading...
Need help?
General
