UM1724 Rev 14 9/68
UM1724 Development environment
67
3 Development environment
3.1 System requirements
• Windows
®
OS (7, 8 and 10), Linux
®
64-bit, or macOS
®
• USB Type-A to Mini-B cable
3.2 Development toolchains
• IAR Systems - IAR Embedded Workbench
®(a)
• Keil
®
: MDK-ARM
(a)
• GCC-based IDEs
• Arm
®
Mbed™ online
(b)
(see http://mbed.org)
3.3 Demonstration software
The demonstration software, included in the STM32Cube MCU Package corresponding to
the on-board microcontroller, is preloaded in the STM32 Flash memory for easy
demonstration of the device peripherals in standalone mode. The latest versions of the
demonstration source code and associated documentation can be downloaded from
www.st.com.
4 Conventions
Table 3 provides the conventions used for the ON and OFF settings in the present
document.
In this document, the references are “STM32 Nucleo board” and “STM32 Nucleo boards” for
all information that is common to all sale types.
a. On Windows
®
only.
b. Refer to the http://mbed.com website and to Table 1: Ordering information, to determine which order codes
are
supported.
Table 3. ON/OFF conventions
Convention Definition
Jumper JP1 ON Jumper fitted
Jumper JP1 OFF Jumper not fitted
Solder bridge SBx ON SBx connections closed by solder or 0-ohm resistor
Solder bridge SBx OFF SBx connections left open
To Next Page
Loading...
Need help?
General
