20
CARE AND MAINTENANCE
Winterizing
CAUTION: Drain the entire system if
there is danger of freezing. A drain plug is
provided at the bottom of the pump case for
this purpose. (Fig 1).
IL1111
PREVENT
PUMP
DAMAGE!
Remove plug
in freezing
weather
1
Please review the following troubleshooting questions before returning a pump as defective.
If you have any questions, please call Customer Service at (800) 742-5044.
√ CHECK LIST
A Check date code to make sure pump is within warranty period. Date code is the month and
the year.
( Example: 0311 is March of 2011. Date Code is found on the top of the pump.)
B Make certain that the power source matches the pump requirements. This pump has a dual
voltage motor and can run on 115V or 230V. See pump label for voltage prewired at the
factory.
C If pump does not run, check the GFI or breaker panel switch to make it is in full operation.
D If the pump runs all the time, make sure the pump has been primed correctly. If pump is not
holding the prime, inspect check valve, foot valve, and piping, then reprime.
E If the pump runs but won’t shut off, check pressure switch.
L1102
MODEL
LIQUID PUMP
LR90197
C
US
UL Std No 778
REV
DATE CODE:/CÓDIGO DE FECHA
Made in USA • Hecho en EE.UU.
FLINT & WALLING, INC. • Kendallville, IN 46755 • USA
A
E
Motor:
HP: 1/2 PH 1 Hz 60
Volts 115/230 S.F. 1.2 Amps 6.4/3.2
S.F. Amps: 8.6/4.3 RPM 3450 Type C
Duty: Cont. Temp 65C KVA Code G
Frame 56L Ins Class B
Factory prewired for 115V Thermally protected automatic
Check voltage of power source Use copper conductors only
g
Dis o ect power source e e uching in rnal pa
p ote n may r s a with u warn n
B
D
QUICK TROUBLE-SHOOTING CHECKLIST
RESET
RESET
TEST
TEST
IL1381
C
To Previous Page
Loading...
Need help?
General
