EN - 18
•
•
particular attention to prevent the
•
– before changing direction
and during tight turns
–
•
•
standstill and unattended.
•
is not engaged, avoid pressing the
6.4
1.
2. Sit in the operator’s position.
3.
4.
5.
6.
7. If cold starting:
8.
running position to engage the electric
circuit. Wait for 2 seconds and turn it to
the start-up position to start the engine.
9.
the engine has started.
10. If cold starting: as soon as
10a.
10b.
NOTE Using the choke when the engine
is already warm can foul the spark plugs
and cause the engine to run erratically.
11. When the engine has started, shift
NOTE If there are engine starting problems,
do not persist as you can risk running the
battery at and ooding the engine. Turn
the key to the O position, wait for a few
minutes and then repeat the operation. If
the malfunction persists, refer to the engine
manual and chapter «14» in this manual.
6.5 OPERATION
6.5.1
without mowing
•
•
• shift the throttle control to a point
•
•
the pedal and operating the throttle.
Drive must be engaged in accordance
with the modes described (paragraph
5.2) to avoid sudden meshing,
jerking start and loss of control of
the vehicle, especially on slopes.
6.5.2 Braking
6.5.3
Reverse must be engaged
when the machine has stopped.
1.
2.
6.5.4 Grass cutting
To Next Page
Loading...
Need help?
General
