EN - 20
• Electrical command
5.
position, press and hold the button
6.
NOTE After emptying the grass catcher bag,
the acoustic signal may be reactivated when the
cutting device are engaged, this is caused by
caused by traces of grass remaining attached
to the indicator micro-switch sensor; if this
happens, disengage and re-engage the cutting
device immediately to silence the buzzer.
6.5.7 Cleaning the discharge chute (for
rear collection models only)
•
instructions provided in chap. 7.6.2.
6.5.8
1.
2.
3.
6.6 STOP
1.
To avoid backre, leave the throttle in
the minimum "tortoise" speed position for
20 seconds before switching o the engine.
2.
3.
4.
To keep the battery
charged, do not leave the ignition key
in the «on» or «headlights on» position
when the engine is not running.
The engine may be very warm
immediately after it is shut o. Do not
touch the exhaust or adjacent parts.
This can cause burn injuries.
6.7
1.
storing in an enclosed space.
2.
3.
contact an Authorised Service Centre.
– Lower the cutting device assembly;
– shift into neutral;
– engage the parking brake;
– stop the engine
– remove the ignition key (making
sure that all moving parts have
come to a complete stop);
•
7.
7.1
The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or hazards.
Before conducting any inspections,
cleaning or maintenance/adjustment
interventions on the machine:
• disengage the cutting device;
• shift into neutral;
• engage the parking brake;
• stop the engine;
• remove the key, (never leave the
keys in the ignition or within reach of
children or unauthorised persons);
• make sure that all moving parts
have come to a complete stop;
• read the relevant instructions;
• use suitable clothing, protective
gloves and goggles
•
To Next Page
Loading...
Need help?
General
