EN - 25
Check that the two rear wheels
are the same height (g. 48.A) and that the
dierence between the external diameters of
the two wheels (g. 48.B) is no greater than
8-10 mm. On the contrary, to avoid uneven
mowing, the cutting device assembly must be
aligned by an Authorised Service Centre.
8.3.5 Repairing or changing tyres
8.4 ELECTRONIC CIRCUIT BOARD
circuit in the event of a fault on the electrical
engine and generates an acoustic signal that
cause or causes of the fault in order to
To avoid tripping the
electronic board protection device:
– do not invert the battery terminals;
– do not operate the machine without the
battery, as this would cause the battery
charge regulator to function irregularly;
– take care to avoid short circuits.
8.5
– 10 A fuse = protects the electronic board
–
–
–
this condition it is still possible to tip the
A blown fuse must always
be replaced by one of the same type and
amperage and never with one of another rating.
8.6 REPLACING BULBS
8.6.1
•
and are installed in the bulb holder,
8.6.2
•
8.6.3 Type “III” - LED light bulbs
1.
2.
3.
4. Raise and release the upper part
5.
6. To replace the bonnet, repeat the
above procedure in reverse order.
8.7 REAR DRIVE UNIT
lubricant does not need changing or topping up.
To Next Page
Loading...
Need help?
General
