'Mounting the Bar and Chain
Removing the chain sprocket
cove~
The guide bar and Oi,lomatic chain are supplied separately.
To
mount them, first unscrew the collar nut
(1)
and take off
the chain sprocket cover (2). On Quickstop models the
chain brake must
be
released before the sprocket cover is
removed,
i.
e.
pUll
hand guard (3) towards handlebar. Take
off and discard cardboard spacer washer.
Now move nut (4) of chain tensioner back as far as the stop
by
turning the tensioning screw (5) counterclockwise.
'locate slot of gUide bar over the stud bolt (6) so that the
peg of the tensioning nut (4) engages
in
the lower fixing
hole
(7).
Starting at the chain sprocket, place the Oilomatic chain on
the guide bar so that the cutting' edges on the top of the bar
are facing the bar nose (8). Push chain sprocket cover (2)
onto stud bolt (6), screw on collar nut
(1)
finger tight.
Top: Backing off the tensioning nut
Center: Locating the guide bar
Bollom: Fitting the Oilomatic chain -
culling edges face the bar nose
21
To Next Page
Loading...
Need help?
General
