ASA 85
English
13
Adjusting length of waist belt
Spare belt (arrow) can be pulled through
the buckle (5) to lengthen the waist belt.
Removing the Backpack
N Open quick release buckles on the
waist belt (1) and chest strap (2).
N Loosen the harness straps by lifting
the sliding adjusters and then take
off the backpack.
N Make sure you have a secure and
firm footing.
N Check that bystanders are well clear
of the general work area of the
pruning shears.
N Hold your cordless pruning shears
firmly.
N Move switch (1) on controller to ON.
Wait for the following acoustic signals
after switch-on:
N Operate the trigger (2) to open the
cutting blade.
The pruning shears are set at the factory
so that the closing motion of the cutting
blade is proportional to the movement of
the trigger.
Switching On
1x Long beep: Electronic control
OK
3x Short beep: Cordless pruning
shears ready for
operation