8
English
BT 360
Always shut off the engine
– before carrying out any
maintenance or repairs
– before changing the drill
Check condition of drills regularly.
Change damaged or dull drills
immediately.
Check tightness of the fuel tank cap at
regular intervals (look for leaks).
Do not touch a hot muffler. Check
condition of muffler at regular intervals to
reduce the risk of fires and damage to
hearing. Do not operate your machine if
the muffler is damaged or missing.
Use only a spark plug of the type
approved by STIHL and make sure it is
in good condition. Inspect ignition lead
(insulation in good condition, secure
connection).
To reduce the risk of fire and burn injury
as a result of sparking outside the
cylinder, move the stop switch to STOP
before turning the engine over on the
starter with the spark plug boot removed
or the spark plug unscrewed.
Store fuel in properly labelled, safety-
type canisters only. Avoid direct contact
with the skin and avoid inhaling fuel
vapor.
Mounting the Handle Frame
: Position the two inner sections (1)
against the underside of the
gearbox. Make sure the off-centre
hinge plates (2) are on the outboard
sides of the tubes.
: Fit the clamps (3) and line up the
holes.
: Insert the hex head screws (4) from
below.
: Fit the plain washers (5) and spring
washers (6). Screw on the nuts (7)
and tighten them down firmly.
: Fit two hex head screws (8) in each
of the retainers (9) – make sure the
retainer snaps into the groove in the
hex head screw.
Assembling the Machine
441BA007 KN
1
2
3
4
5
6
7
441BA008 KN
8
9
9
8
To Next Page
Need help?
General
