When correctly installed, the red line (3) (arrow
point) must be flush with the end of the coupling
sleeve.
► Tighten down the star knob (4) firmly.
7.1 Removing the KombiTool
► Reverse the above sequence to remove the
drive tube.
8 Mounting the Cutting Blade
► Place the edger so that the blade mounting (1)
faces upwards
► Insert the locking pin (2) as far as possible into
the bore (3), push lightly and rotate back and
forth a little together with the thrust washer (4)
until the shaft is blocked.
► Fit Allen wrench (5) onto nut (6).
► Turn nut clockwise (left-hand thread) and
remove it.
► Remove the thrust washer.
► Position the blade (7) on the thrust plate (8).
WARNING
The collar (arrow) must engage the hole in the
blade.
► Fit the thrust washer (4) on the shaft (9) and
block the shaft.
► Screw nut (6) counterclockwise onto shaft and
tighten.
WARNING
If the cup spring (10) on the nut (6) becomes
fatigued, then the nut must be replaced!
9 Starting / Stopping the
Engine
9.1 Starting the engine
To start the engine, basically follow the instruc‐
tions for use for the KombiEngine or basic power
tool!
English 8 Mounting the Cutting Blade
10 0458-471-0121-C
To Next Page
Loading...
Need help?
General
