Adjust correctly
The depth of cut depends on the unevenness of
the ground, your height and the way you hold the
edger. Use the following procedure:
► Adjust the depth wheel (2) so that the
blade (3) just touches the ground or breaks
the surface of the soil by no more than
5 mm (B)
► Tighten down the wingnut clockwise.
► Standing in the normal working position, check
the depth of cut again and correct it if neces‐
sary.
WARNING
Do not adjust the deflector.
The deflector has been set at the factory so that
the arrow on the deflector and the open side
point away from the operator. This ensures that
cuttings and other debris are directed away from
the power tool and operator.
4 Using the Unit English
0458-471-0121-C 7
To Next Page
Loading...
Need help?
General
