Stihl FS User Manual

FS
English
46
Securing the Loop Handle
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 20 cm (8 in)
N Slide the handle to the required
position.
N Line up the loop handle (4).
N Tighten down the screws until the
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
The sleeve (9) (not fitted on all models)
must be between the loop handle and
the control handle.
Preparations for Mounting the
Attachment
WARNING
To reduce the risk of injury, always shut
off the engine before converting the
basic power tool.
NOTICE
Make sure the work area is clean before
mounting or removing the attachment.
N Rest the power tool on the machine
support.
Removing the protective cap
If a cap is fitted on the end of the power
tool's drive tube:
N Pull the protective cap off the end of
the drive tube and keep it in a safe
place.
If the plug comes out of the drive tube
when you pull off the cap:
N Push the plug into the drive tube as
far as stop.
Removing the gearbox or attachment
Remove any existing gearbox or
interchangeable attachment from the
basic power tool.
9
4
A
002BA615 KN
Mounting the Attachment
413BA014 KN
002BA248 KN
228BA092 KN
BF
228BA090 KN
FCS

Stihl FS Specifications

General

Brand	Stihl
Model	FS
Category	Garden Machinery Accessories
Language	English