FS
English
58
N Swing wire rod outwards.
N Fit transport guard on saw blade
from below, making sure the limit
stop is properly seated in the
recess.
N Swing wire rod into position.
N Hook wire rod to the transport
guard.
N Check the grease level regularly –
about every 25 hours of operation.
N Unscrew the filler plug (1). If no
grease can be seen on the inside of
the filler plug, screw the tube (2) of
STIHL gear lubricant (special
accessory) into the filler hole.
N Squeeze up to 5 g grease into the
gearbox.
NOTICE
Do not completely fill the gearbox with
grease.
N Remove the tube of grease (2).
N Refit the filler plug (1) and tighten it
down firmly.
For periods of about 3 months or longer
N Remove, clean and inspect the
cutting attachment. Coat metal
cutting attachments with corrosion
inhibitor.
N Store the machine in a dry and
secure location Keep out of the
reach of children and other
unauthorized persons.
Lubricating the Gearbox
Storing the Machine
To Next Page
Loading...
Need help?
General
