Stihl GHE 355 User Manual

EN
19
0478 201 8314 C - EN
9.2 Safety interlock
The motor/shredding tool may only be
operated when the feed chute has been
properly closed. If the right closure screw
(machine viewed from the front) becomes
loose during operation, the motor is
switched off automatically and after a few
seconds the shredding tool comes to a
standstill.
9.3 Motor run-down brake
The motor run-down brake shortens the
run-down time from when the machine is
switched off until the blades stop to a few
seconds.
9.4 Protective covers
The garden shredder is equipped with
protective covers in the feeding and
ejection areas. These include the
complete feed chute with the upper chute
and splash guard, the ejection chute
extension and the discharge flap.
The protective covers ensure that a safe
distance is maintained from the shredding
blades.
● Switch on the motor only as described
in the operating instructions. (Ö 10.4)
10.1 Electrical connection of garden
shredders
Power supply and operating voltage must
correspond (see rating plate).
The power cable must be adequately
protected by fuse in line with the
respective national electrical installation
regulations. (Ö 16.)
Only electric cables which are no lighter
than rubber sheathed cables H07 RN-F
may be used.
The minimum cross-section of the power
cable must be 3x1.5mm² for a length of
up to 25 m or 3x2.5mm² for a length of
over 25 m.
The plug connections must be splash
proof.
Unsuitable extension cables lead to a loss
of power and may result in damage to the
motor.
Extension cable plugs and connectors
must conform to the standard AS/NZS
3112.
Use a splash-proof coupling box
(protection class IPX4) when using an
extension cable.
This machine is intended for operation with
a power supply having a system
impedance of Z
max
at the transfer point
(house connection) of maximum
0.323 ohms at 50 Hz.
The user must ensure that the machine is
only operated with a power supply which
meets this requirement.
If necessary, this information can be
obtained from the local electric power
company.
10.2 Connecting the power cable
● Insert the machine plug in the socket.
10.3 Disconnecting the power cable
10.4 Switching on the garden shredder
10. Operating the machine
Risk of injury!
Carefully read the section entitled
"For your safety" (Ö 4.) and follow
all the safety instructions before
operating the garden shredder.
Risk of injury!
Observe the instructions in the
"Warning – dangers caused by
electrical current" section (Ö 4.2).
Your electrician can provide further
information on mains connection.
When choosing a power cable, take
account of all the information in the
"Electrical connection" section
(Ö 10.1).
Disconnect the power cable only by
pulling the connector. Never pull the
cable.
If the power cable is disconnected
during operation of the garden
shredder, the machine can only be
restarted after a delay of
12 seconds.
There must be no shredding
material in the machine when it is
switched on as it may be expelled.
The blade disc locking device must
always be tilted back to the stop.
(Ö 11.6)
The garden shredder cannot be
switched on if the preselector
switch is vertical (centre position).

Stihl GHE 355 Specifications

General

Power	2500 W
Product color	Black, Orange, White
Uncertainty K	2.4 dB
Cutting system	Blade
AC input voltage	230 V
Transport wheels	Yes
Rated speed (max)	2750 RPM
Sound power level	100 dB
Material throughput	- kg/h
Sound pressure level	94 dB
Collection box capacity	- L
Maximum branch thickness	35 mm

Weight and Dimensions

Weight	30000 g