HL-KM
English
8
Horizontal Cut (with straight cutter bar)
Hold the cutter bar at an angle of 0° to
10° as you swing the hedge trimmer
horizontally.
Swing the cutter bar in an arc towards
the outside of the hedge so that the
cuttings are swept to the ground.
Recommendation: Only cut hedges that
are no more than chest height.
KombiEngines
Only use KombiEngines supplied or
explicitly approved by STIHL for use with
the attachment.
This KombiTool may be operated only in
combination with the following
KombiEngines:
KM 56 R, KM 85 R
1)
, KM 94 R,
KM 111 R, KM 131, KM 131 R, KMA
130 R
WARNING
The HL-KM 0° is not approved for use
on KombiEngines with a bike handle.
Brushcutters with split drive tube
This KombiTool may also be mounted to
STIHL brushcutters (basic power tools)
with a split drive tube (T models).
Operation of this KombiTool is therefore
also permitted on the following power
tool model:
STIHL FR 131 T
WARNING
Refer to the power tool's instruction
manual for use of the barrier bar.
Approved KombiEngines
To Next Page
Loading...
Need help?
General
