17KM 110, KM 130
English / USA
Opening the cap
: Raise the grip until it is upright.
: Turn the cap counterclockwise
(approx. a quarter turn).
: Remove the filler cap.
Closing the cap
: Fit the cap – grip upright –marks
must line up.
: Turn the cap clockwise as far as
stop (approx. a quarter turn).
: Fold the grip flush with the top of the
cap.
: If the grip does not lie completely
flush with the cap and the detent on
the grip does not engage the recess
in the filler neck, the cap is not
properly seated and tightened and
you must repeat the above steps.
Controls
Control handle on bike handle
Throttle trigger interlock (1), throttle
trigger (2) and slide control (3).
Starting / Stopping
the Engine
3
STOP
56
4
7
002BA182 KN
1
2
START
STOP-