25KW 85
english / USA
: Straighten the ends of the cotter pin,
remove the cotter pin.
: Pull the sweeper drum off the shaft.
: Examine gear housing for signs of
oil. If leaks are found, have your
STIHL dealer check the gearbox.
: Repeat the above procedure on the
other side.
: Release the clamp screw (1).
: Pull the gearbox (2) off the drive
tube (3) - turn the gearbox back and
forth at the same time to ease
removal.
The rubber sleeve protects the drive
tube from wear caused by contact with
the sweeper belts. It is fitted on either the
drive tube or the gearbox.
A worn sleeve must be replaced as
follows:
: Remove the gearbox -
see "Removing the Gearbox".
Sleeve on drive tube
: Remove the worn sleeve from the
drive tube. Cut it open with a knife if
necessary.
Sleeve on gearbox
: Pull the worn sleeve off the gearbox.
: Push new sleeve onto the gearbox.
: Install the gearbox - see "Installing
the Gearbox".
Removing the Gearbox
223BA022 KN
3
223BA015 KN
1
2
Replacing the
Rubber Sleeve
223BA025 KN
223BA032 KN
223BA033 KN
To Next Page
Loading...
Need help?
General
