Stihl MS 192 T Manual

20 MS 192 T
: Fit the clutch on the crankshaft
stub so that the raised hexagon
(arrow) is visible.
217RA084 TG
: Screw the clutch (1) with
hexagon (arrow) onto the
crankshaft stub and tighten it
down.
: Tightening torques, b 3.5
– Pull the locking strip out of the
217RA022 TG
1
cylinder.
– Reassemble remaining parts in
reverse order.
– Remove the clutch, b 6
: Draw the sprocket (1) off the
crankshaft stub.
217RA023 TG
1
: Remove the needle cage (1) from
the sprocket.
– Clean the needle cage and
crankshaft stub with standard
solvent-based degreasant not
containing any chlorinated or
halogenated hydrocarbons.
217RA024 TG
1
– Examine the sprocket (1) for
signs of wear.
If there are distinct signs of wear on
the inside diameter of the sprocket
(1), the remaining thickness must
be measured. The sprocket must be
replaced if less than 80% of the
VA
148RA101
80%
100%
1
!
original thickness remain.
– Reassemble parts in reverse
order.
– Grease the needle cage and
crankshaft stub, b 16
: Slip the needle cage (1) onto the
crankshaft stub.
217RA058 TG
1
6.1 Sprocket / Clutch Drum

Stihl MS 192 T Specifications

General

Brand	Stihl
Model	MS 192 T
Category	Chainsaw
Language	English