Stihl MSE 170 C User Manual

MSE 170 C, MSE 210 C
English
20
N Make sure the drive link tangs
engage the bar groove (arrow) and
then rotate the tensioning gear
counterclockwise as far as stop.
N Place the chain sprocket cover in
position and engage the guide lugs
in the recesses in the handle
housing.
When fitting the chain sprocket cover,
check that the teeth of the tensioning
gear and adjusting wheel mesh properly.
N If necessary, turn the adjusting
wheel (4) slightly until the sprocket
cover can be pushed flush against
the handle housing.
N Pull the hinged handle (5) out until it
engages in the upright position.
N Fit the wingnut and tighten it
moderately – finally tighten the
wingnut by hand only after
tensioning the saw chain.
N Go to chapter on "Tensioning the
Saw Chain"
Retensioning during cutting work:
N Disconnect the plug from the wall
outlet.
N Pull out the hinged grip and loosen
the wingnut.
N Turn the adjusting wheel (1)
clockwise as far as stop.
N Tighten down the wingnut (2) firmly
by hand.
N Fold down the hinged grip.
N Go to "Checking Chain Tension".
A new chain has to be retensioned more
often than one that has been in use for
some time.
N Check chain tension frequently –
see chapter on "Operating
Instructions".
9931BA020 KN
9931BA021 KN
4
9931BA022 KN
5
Tensioning the Saw Chain
(quick chain tensioner)
1
9931BA024 KN
2

Stihl MSE 170 C Specifications

General

Brand	Stihl
Model	MSE 170 C
Category	Chainsaw
Language	English