Stihl RE 110 User Manual

0458-620-8221-A
23
English 9 Connecting the Water Supply
Disconnecting the Water Hose
To disconnect the water hose:
► Switch off the pressure washer, @ 10.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Pull the spray gun trigger to relieve pressure.
► Lock the spray gun trigger.
► Remove the water hose (4) from the coupling (1) onto the
pressure washer or water filter (2).
9.2 Connecting the pressure washer to another
water source
The pressure washer can draw water from water butts and
cisterns and from running or stagnant bodies of water.
So that the water can be drawn in, the height difference
between the pressure washer and the water source should
not exceed the maximum suction lift (a), @ 18.1.
The appropriate STIHL suction set must be used. The
suction set includes a water hose with a special coupling.
Depending on the market, the appropriate STIHL suction set
may be supplied with the pressure washer.
Connecting the water filter
If operating the pressure washer with sandy water from
water butts, cisterns or running or stagnant bodies of water,
a water filter must be connected in-line between the water
hose and the pressure washer.
To connect the water filter:
► Unscrew the coupling (1).
► Screw the water filter (2) onto the connector (3) and
tighten by hand.
0000-GXX-7026-A0
1
4
4
1
2
a
0000-GXX-5093-A0
3
1
0000-GXX-7027-A0
2

Stihl RE 110 Specifications

General

Form factor	Upright
Hose length	7 m
Cable length	5 m
Power source	Electric
Product color	Black, Orange
Pump material	Aluminum
Detergent tank	-
Maximum flow rate	440 l/h
Minimum flow rate	380 l/h
Sound power level	81 dB
Vibration emission	1.8 m/s²
Working pressure (max)	120 bar
Working pressure (min)	110 bar
Maximum water temperature	40 °C
AC input voltage	230 V
Power consumption (typical)	- W

Weight and Dimensions

Weight	17600 g