0458-620-8221-A
24
English
10 Switching the Pressure Washer On and Off
Connecting the water hose
To connect the pressure washer to another water source:
► Fill the water hose (5) with water until there is no air left in
the water hose.
► Screw the coupling (4) onto the water filter (2) and tighten
by hand.
► Suspend the suction cup (6) in the water source so that
the suction cup (6) does not touch the bottom.
► If the spray gun is attached to the high-pressure hose:
remove the spray gun.
► Hold the high-pressure hose downward.
► Switch on pressure washer and run it until an even jet of
water is delivered by the high-pressure hose.
► Switch off the pressure washer.
► Attach spray gun to the high-pressure hose.
► Squeeze and hold down spray gun trigger.
► Switch on the pressure washer.
10.1 Switching On
WARNING
Never operate your pressure washer if it is damaged,
improperly adjusted or maintained, not completely and
securely assembled or not functioning properly, @ 5.5. To
reduce the risk of personal injury, always wear proper
clothing and protective apparel, including proper eye
protection, when operating your pressure washer, @ 5.4.
Before switching on:
► Make sure you have a secure and firm footing.
► Stand upright.
► Always hold and operate the pressure washer with one
hand firmly on the spray gun and your other hand firmly on
the spray lance. Always hold the pressure washer with two
hands in this manner.
To switch the pressure washer on:
► Set the switch to the I position.
0000-GXX-7028-A0
5
6
4
2
5
10 Switching the Pressure Washer On
and Off
0000-GXX-4357-A0
To Next Page
Loading...
Need help?
General
Weight and Dimensions
